How To Light A Electric Hot Water Tank

How To Light A Electric Hot Water Tank. This causes the gas valve to provide enough gas to light the pilot light with. Then, turn the on/off/pilot dial downwards and push the igniter button at the same time.

Water heater shutdown, relight, and maintenance YouTube from www.youtube.com

Place a plastic twist cap onto the wires and twist it several times. Turn the dial to the on position. Before attempting to light an rv water heater pilot step 1:

Check For Any Open Valves Or Faucets.

Hold down the regulator valve knob for at least one minute after the pilot has been lit. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. Turn the water heat dial to low and the on/off/pilot dial to pilot.

Watch Through The Glass And Make Sure The Pilot Stays Lit.

After that you can set the thermostat to the desired temperature. While holding the knob in, light a match or your butane lighter and. Locate the on/off control knob for the pilot light and turn the knob to the pilot setting on the unit.

Remove The Access Panel, Insulation, And Plastic Safety Guard From Each Heating Element On The Water Heater.

Check the heat setting on both thermostats: The tools needed to light pilot light in water heater. Then, turn the pilot dial until it says the word pilot.

Turn The Dial To The On Position.

I am not a professional, just documenting how i repaired the hot water heater's pilot light to stay on. This will start the flow of gas so you can light the flame. Push down the red button to the left of the gas knob.

Change The Temperature To Low, And Switch To Pilot.

You should hear a whooshing sound as the burner ignites. Then, turn the on/off/pilot dial downwards and push the igniter button at the same time. There should be an immediate flame.